NETWORK 1
1GBaseT – 10GBaseT
The IT industry has long replaced copper with optical fibre for transmission over long distances and high-volume data transmission. Because of this, a wide variety of standard network components are available for setting up an optical fibre network.
KLOTZ AIS has the ideal optical fibre cables for your needs in its extensive catalogue! A popular choice in widespread use is a star setup with two network switches with SFP slots (small form-factor pluggable, also mini-GBIC). Each is connected to an SFP+ module suitable for the application, which contains the laser diodes and usually has LC duplex sockets. With this interface, it’s simple to connect matching KLOTZ FiberLink cables to cover the distance to the second switch. We use this system ourselves at KLOTZ AIS to link up our locations in Vaterstetten and Vilchband.
FB8ZMDL
FiberLink SmartBeam OCTO D-series to 8x LC/PC multimode installation adapter
TP1NFX06FF
termination panel for 6x SmartBeam D series or opticalCON
F8UM11
FiberLink SmartBeam OCTO multimode cable drum
TP1NFX06FF
termination panel for 6x SmartBeam D series or opticalCON
FB8ZMDL
FiberLink SmartBeam OCTO D-series to 8x LC/PC multimode installation adapter
FOPDXM3LL
multimode fiber optic duplex patch cable OM3: LC/PC- LC/PC
FDP-1S8OCLM
19“ fiber distribution panel OCTO, multimode fiber optic signal distribution, 1x SmartBeam OCTO – 4x LC/PC Duplex opticalCON
F8UM11
FiberLink SmartBeam OCTO multimode cable drum
FDP-1S8OCLM
19“ fiber distribution panel OCTO, multimode fiber optic signal distribution, 1x SmartBeam OCTO – 4x LC/PC Duplex opticalCON
FOPDXM3LL
multimode fiber optic duplex patch cable OM3: LC/PC- LC/PC
NETWORK 2
version with 19‘‘ fiber distribution panels
The IT industry has long replaced copper with optical fibre for transmission over long distances and high-volume data transmission. Because of this, a wide variety of standard network components are available for setting up an optical fibre network.
KLOTZ AIS has the ideal optical fibre cables for your needs in its extensive catalogue! A popular choice in widespread use is a star setup with two network switches with SFP slots (small form-factor pluggable, also mini-GBIC). Each is connected to an SFP+ module suitable for the application, which contains the laser diodes and usually has LC duplex sockets. With this interface, it’s simple to connect matching KLOTZ FiberLink cables to cover the distance to the second switch. We use this system ourselves at KLOTZ AIS to link up our locations in Vaterstetten and Vilchband.
NETWORK 3
Ethernet extender over fiber
The EXT2K11S Extender Set is way out ahead – up to 10 km ahead, in fact! Network data (DanteTM, Artnet etc.) are input and output through two RJ45 connections on both transmitter and receiver. The units are connected by our FiberLink single-mode cable, and each have a built-in SmartBeam DUO connector designated for the purpose.
The technical facts speak for themselves: compatibility with standards IEEE802.3 10Base-T, IEEE802.3U 100Base-TX/FX and IEEE802.3Z 1000Base-T, supports QOS and VoIP, full duplex and half-duplex operation. And thanks to MDI/MDIX support, the need for crossover cables is eliminated.